2 - SAFETY PRECAUTIONS
2-3. INTERNATIONAL SYMBOLS
Minimum operating distance
Use of these personal safety items is highly recommended to
reduce the risk of accidental injury.
Read the User Manual.
Pump the primer bulb 10 times.
6
3 - ASSEMBLY INSTRUCTIONS
3-1. "P" HANDLE ASSEMBLY
1.
To install handle onto unit, you will need the following
components from your user kit: "P" handle (A & B),
screws (C) and nuts (D). (Figure 3-1).
2.
Install the handle (B) on the shaft 6.0" to 7.87" (160-
200mm) fromthrottle and tighten the 2 screws (C) and nuts (D).
A
C
B
D
3-1A
3-2. DEBRIS SHIELD
1.
Remove gear collar (A) from the threaded gear hous-
ing shaft. Ensure collar spacer (B) is in place (Fig. 3-
2A).
2.
Install debris shield with 3 screws (C) provided (Fig. 3-
2B).
A
B
3-2A
C
3-2B
3-3. STRINGHEAD INSTALLATION
1.
Install gear collar (A) ensuring that COLLAR SPACER
(B) is in place (Fig. 3-3A).
2.
Insert holding pin (C) and thread stringhead onto
shaft. Tighten stringhead by HAND ONLY (Fig. 3-3B
and 3-3C).
A
B
3-3A
C
3-3B
C
3-3C
7