Download  Print this page

Customizing Features / Options - Whirlpool WHES48 Installation & Operation Manual

Hide thumbs

Advertisement

Customizing Features / Options

POWER OUTAGE MEMORY
If electrical power to the water softener is lost, "mem-
ory'' built into the electronic control circuitry will keep
all settings for up to six hours. While the power is
out, the display is blank and the water softener will
not regenerate. When electrical power is restored,
the following will occur.
You have to reset the current time only if the display's
backlight is flashing and the Set time screen is dis-
played instead of the softener's status screen.
Even if the clock is incorrect after a long power out-
age, the softener operates as it should to keep your
water soft. However, regenerations may occur at the
wrong time of day until you reset the clock to the cor-
rect time of day.
NOTE: If the water softener was regenerating when
power was lost, it will now finish the cycle.
RESTORE FACTORY SETTINGS
This feature resets the softener's electronic controller
to its initial startup condition. All settings, such as lan-
guage, current time and water hardness, are cleared
and returned to their default values. The user must
then follow the setup procedure (See Page 12) before
the softener will be ready to run again.
1. Press the SETUP button on the softener status
screen.
2. Press the LEFT ( ) button twice to display the
screen shown in Figure 75.
3. Press the ADVANCED SETUP button. The display
will change to the following screen.
4. Press the LEFT ( ) button to display the screen
shown in Figure 77.
5. Press the RESTORE FACTORY SETTINGS button
and the display will change to show the Restore
factory settings screen (See Figure 78).
6. Press the button next to YES and then press the
RETURN ( ) button.
7. Follow the setup procedure on Page 12.
22
FIG. 75
FIG. 76
FIG. 77
FIG. 78

Advertisement

Table of Contents
loading

  Also See for Whirlpool WHES48

  Related Manuals for Whirlpool WHES48