Download  Print this page

Whirlpool WHES48 Installation & Operation Manual page 17

Hide thumbs

Advertisement

Programming Your E-Z Touch Water Softener
SET HARDNESS
When the softener's electronic control is first powered
up, the setup procedure prompts you to enter your
water's hardness (See Page 12). To change it:
1. Press the SETUP button on the softener status
screen (See Figure 45).
2. Press the RIGHT ( ) button to display the screen
shown in Figure 46.
3. Press the SET HARDNESS button and the display
will change to show the Set hardness screen (See
Figure 47).
4. Press the UP ( ) or DOWN ( ) buttons to set the
value for your water's hardness. Hold the button
down to rapidly advance. When the correct hard-
ness is shown, press the RETURN ( ) button.
NOTE: Do not increase the hardness setting to com-
pensate for iron in your water. The electronic
control will compensate automatically after
you set the iron level, as described under "Set
Iron Level" on this page.
5. To return to the softener status screen, press the
RETURN ( ) button.
SET RECHARGE TIME
Refer to Page 15 for instructions on setting the start
time for automatic recharges.
SET IRON LEVEL
The softener's electronic control can adjust cycle
times to compensate for ferrous (clear water) iron in
the water. When the softener's electronic control is
first powered up, the iron level is set at 0.
NOTE: The iron level will always be displayed in ppm
To enter your water's iron level:
FIG. 45
1. Press the SETUP button on the softener status
screen (See Figure 45).
2. Press the RIGHT ( ) button three times to display
the screen shown in Figure 48.
FIG. 46
FIG. 47
3. Press the SET IRON LEVEL button and the display
will change to show the Set iron level screen (See
Figure 49).
4. Press the UP ( ) or DOWN ( ) buttons to set the
value for iron in your water. Hold the button down
to rapidly advance. When the correct iron level is
shown, press the RETURN ( ) button.
5. To return to the softener status screen, press the
RETURN ( ) button.
17
(parts per million), regardless of whether the
Hardness units setting is grains or ppm. The
conversion factor is 3 grains per ppm of clear
water iron.
FIG. 48
FIG. 49

Advertisement

Table of Contents
loading

  Also See for Whirlpool WHES48

  Related Manuals for Whirlpool WHES48