Foxconn M7PMX series User's Manual page 42

SuperIO Devices
OnBoard FDC Controller
OnBoard Serial Port 1
IR IO/IRQ Select
UART Mode Select
IrDA Duplex Mode
↑↓→←:Move Enter:Select
► OnBoard FDC Controller
This item is used to enable or disable the onboard FDC controller.
► OnBoard Serial Port 1
This item is used to assign the I/O address and interrupt request (IRQ) for the onboard serial
port COM1.
► IR IO/IRQ Select
This item is used to assign the I/O address and interrupt request (IRQ) for the onboard infraed
chip.
► UART Mode Select
This item is used to configure COM1 port as :
[Normal] : a RS232 device. IrDA port has no function.
[irDA] : an IrDA device for maximum baud rate of 115200 bit/s. COM1 port has no function.
[ASKIR] : A faster IrDA for 1152000 bit/s. COM1 port has no function.
► IrDA Duplex Mode
This item enables you to determine the infrared function of the onboard infrared chip.
Phoenix - AwardBIOS CMOS Setup Utility
SuperIO Devices
[Enabled]
Enabled
[3F8/IRQ4]
[2F8/IRQ3]
[IrDA]
[Half]
+/-/PU/PD:Value F10:Save
F5:Previous Values
35
Item Help
Menu Level ►
ESC:Exit F1:General Help
F7:Optimized Defaults