Foxconn M7PMX series User's Manual page 21

front Panel Connector : fP1
This motherboard includes one connector for connecting
the front panel switch and LED Indicators.
Hard Disk leD Connector (HDD-leD)
Connect to the chassis front panel IDE indicator LED. It
indicates the active status of the hard disks. This 2-pin
connector is directional with +/- sign.
Reset Switch (ReSeT-SW)
Attach the connector to the Reset switch on the front
panel of the case; the system will restart when the
switch is pressed.
Power leD Connector (PWR-leD)
Connect to the power LED indicator on the front panel
of the chassis. The Power LED indicates the system's
status. When the system is in operation (S0 status),
the LED is on. When the system gets into sleep mode
(S1) , the LED is blinking; When the system is in S3/S4
sleep state or power off mode (S5), the LED is off. This
2-pin connector is directional with +/- sign.
Power Switch Connector (PWR-SW)
Connect to the power button on the front panel of
the chassis. Push this switch allows the system to be
turned on and off rather than using the power supply
button.
Serial ATA Connectors : SATA_1/2/3/4
The Serial ATA connector is used to connect with relevant
Hard Disk or CD devices which support this feature. The
current Serial ATA II interface allows up to 300MB/s data
transfer rate.
fan Connectors : CPU_fAN, SYS_fAN
There are two fan connectors on this motherboard. The fan
speed can be detected and viewed in "PC Health Status"
section of the BIOS Setup. These fans will be automatically
turned off after the system enters S3, S4 and S5 mode.
HDD-LED
RESET-SW
1
SYS_FAN/CPU_FAN
14
1 2
+ +
PWR-LED
-
-
PWR-SW
EMPTY
NC
10
9
FP1
GND
1
TX+
TX-
GND
RX-
RX+
GND
SATA_1/2/3/4
GND
POWER
SENSE
CONTROL