Braun PrecisionSensor Pro BP 2590 Instructions Manual page 8

8
3. When a measuring position has been reached,
you will hear a tone and the display shows a heart
symbol. Both indicate that the appropriate
measuring position has been reached.
The measurement now starts automatically.
4. When the measurement is complete, a tone will
sound again, and the reading is displayed.
Upper (systolic) value
Lower (diastolic) value
Pulse
Additionally, on the upper display section, three
status boxes will appear to confirm that the
appropriate measuring position was kept during the
complete measuring process.
All three boxes should show «OK». If the following
r
symbols (« » = too high; «
appropriate measuring position was not maintained
and the measurement should be repeated.
Important
15 seconds after switching on the device, the
measuring process will start automatically, even if
the appropriate measuring position has not been
reached. If an appropriate position has not been
reached, the blood pressure reading may be
affected. If at any time you want to discontinue the
measurement, press the «I/0» button.
Memory
The blood pressure monitor can store up to
30 readings along with the above mentioned status
box information. Readings are stored automatically
after each measurement.
w
» = too low) appear, the