Advertisement
Checking the pre-assigned CAPN module buttons
About pre-
assigned buttons
Checking the pre-
assigned CAPN
module buttons
Customising your
CAPN module
Page 2 Enterprise Edge CAPN User Card
When one or two CAPN modules are first plugged into your telephone,
each CAPN module button is pre-assigned either to select a line or dial
an internal number.
If you have been assigned up to 8 lines, you can select them by pressing
the buttons in the left-hand column of your M7324N Telephone.
Remaining lines are assigned to buttons on the CAPN module(s),
beginning at the top left-hand corner of the first CAPN module and
moving down.
After lines are assigned, any remaining buttons on your CAPN module(s)
become Internal Autodial buttons, starting with the lowest default internal
number. These internal numbers can be between two and seven digits.
The numbering length is controlled in programming.
Note: In order for lines to be automatically assigned to buttons on your
CAPN module, your telephone must first be designated as a CAPN
in programming.
1. Replace the handset.
ƒ•‚
2. Press
3. Press the buttons you want to check and read the display.
4. Ensure that you label all pre-assigned line buttons and Internal Autodial
buttons correctly in the space provided beside each button.
ƒ
5. Press
when you are finished.
You can program any of the buttons on your CAPN module that do not
select lines. These buttons can be programmed to automatically dial
internal or external numbers. You can also program features onto CAPN
module buttons. If you want more line buttons programmed, see your
System Administrator.
Your CAPN module will be most effective if you use it along with the Call
Park, Transfer, Conference/Transfer, Camp-On, Message, or Voice Call
features.
Make sure that these features are programmed on your CAPN module by
following the steps presented in this card.
+
.
Advertisement
