Carton Contents; Blower Assembly - McCulloch MAC GBV 325 Instruction Manual

14
2
1
6
5
3
WHAT IS WHAT?
1. Throttle trigger 9.
2. STOP switch 10. Lower blower tube
3. Primer button 11. High- -speed nozzle
4. Choke lever 12. Elbow tube
5. Fuel cap 13. Vacuum bag
6. Starter rope 14. Upper vacuum tube
7. Vacuum handle 15. Lower vacuum tube
8. Spark plug 16. Instruction manual

CARTON CONTENTS

Check carton contents against the following list.
S Blower
S Upper blower tube
S Lower blower tube
S High velocity nozzle
S Elbow tube
S Vacuum bag
S Upper vacuum tube
S Lower vacuum tube
S Screw for vacuum tube assembly
NOTE:
It is normal for the fuel filter to rattle
in the empty fuel tank.
ASSEMBLY
WARNING:
Stop engine and be sure
the impeller blades have stopped turning be-
fore opening the vacuum inlet door or at-
tempting to insert or remove the vacuum or
blower tubes. The rotating blades can cause
serious injury. Always disconnect the spark
plug before performing maintenance or ac-
cessing movable parts.
WARNING:
If received assembled,
repeat all steps to ensure your unit is properly
WHAT IS WHAT?
15
12
8
9
4
7
Upper blower tube
ASSEMBLY
assembled and all fasteners are secure. Fol-
low all safety information in the manual and on
the unit.
A standard screwdriver is required for as-
D
sembly.

BLOWER ASSEMBLY

BLOWER TUBE ASSEMBLY
1. Align the rib on the upper blower tube with
the groove in the blower outlet; slide the
tube into place.
NOTE:
The tube clamp bolt must be loose
enough to allow blower tube to be inserted in
blower outlet. Loosen the bolt by turning coun-
terclockwise (do not remove nuts).
2. Secure the tube by turning the bolt clock-
wise.
3. Align the slots on the lower blower tube
with the tabs on the upper blower tube.
-- 4 --
13
10
11
16
Blower Outlet
Rib
Groove