Instructions For Installation; Removing The Old Water Heater - Maytag SERIES NINE HE2940L User Manual

Series nine
Table of Contents

Advertisement

Instructions for Installation
Removing the Old Water Heater
QTurn
"OFF" electrical supply to the water heater.
('_
a. If you have
piping to the water heater, the two
copper
copper water pipes can be cut with a hacksaw approxi-
mately four inches away from where they connect to
the water heater. This will avoid cutting off the pipes
too short. Additional cuts can be made later if neces-
sary. Disconnect the temperature-pressure relief valve
drain fine. When the water heater is drained, discon-
nect the hose from the drain valve. Close the drain
valve. The water heater is now completely disconnect-
ed and ready to be removed.
QTUrnorwa ermeter."OFF"
the water supply to the
I_Q
watertheaterat
the water shutoff valve
Attach
hose
the
heater drain
a
to
water
valve and put the other end in a floor
_[_--
'[1
Ob.
If you have galvanized pipe to the water
drain or outdoors.
Open
the water
l_]
heater, loosen the two galvanized pipes
heater drain valve. Open a nearby hot
with a pipe wrench at the union in each
water faucet which will relieve pressure
line, Also disconnect the piping remain-
in the water heater and speed draining,
ing to the water heater. These
pieces
should be saved since they may be needed
Disconnect
the temperature-pressure
relief valve discharge
pipe. When
the
water heater is drained, disconnect
the
hose from the drain valve. Close the drain
valve. The water heater is now completely
disconnected and ready to be removed.
&WARNING
The water
passing out of the drain
valve
may be extremely
hot. To
I _
avoid being scalded, make sure all
connections are tight and that the
"
water
flow is directed
away from
any person.
Q
Check again to make sure the electrical supply is turned
"OFF" to the water heater. Then disconnect the electri-
cal supply connection
from the water heater junction
bOX.
mtl I
ACAUTION
Mineral
buildup or sediment
may have accumulated I
in the old water
heater.
This causes the water[
-_lb
_
heater to be much heavier than normal and this
residue, if spilled out, could cause staining.
8

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents