Removing The Old Water Heater - Maytag HE21240S User Manual

Series twelve electric water heater
Table of Contents

Advertisement

Installation Instructions
Removing the Old Water Heater
Turn "OFF" electrical supply to the water heater.
(_
have
the
the
If you
piping
a.
copper
tO
water
heater,
two
copper water pipes can be cut with a hacksaw approxi-
@__
mately four inches away from where they connect to
the water heater. This will avoid cutting off the pipes
too short. Additional cuts can be made later if neces-
sary. Disconnect the temperature-pressure
relief valve
drain line. When the water heater is drained, discon-
nect the hose from the drain valve. Close the drain
valve. The water heater is now completely disconnect-
ed and ready to be removed.
@
Turn "OFF" the water supply to the
,
]_ @
water heater at the water shutoff valve
_,_=
I ]
or water meter.
Attach a hose to the water heater drain
valve and put the other end in a floor
_[_-- --- I_
('_)b.
If you have galvanized pipe to the water
drain or outdoors.
Open
the water
U
_
heater, loosen the two galvanized pipes
heater drain valve. Open a nearby hot
with a pipe wrench at the union in each
water faucet which will relieve pressure
line. Also disconnect the piping remain-
in the water heater and speed draining,
ing to the water heater. These
pieces
should be saved since they may be needed
__
when reconnecting the new water heater.
Disconnect
the temperature-pressure
relief valve drain line. When the water
heater is drained,
disconnect
the hose
from the drain valve. Close the drain
valve. The water heater is now completely
II'-
- [[
disconnected and ready to be removed.
The water _'passingWARNINGout
of the drain
__1
t1__
valve
may be extremely
hot. To
avoid being scalded, make sure all
connections are tight and that the
water
flow is directed
away from
,_
any person.
Check again to make sure the electrical supply is turned
"OFF" to the water heater. Then disconnect the electri-
cal supply connection
from the water heater junction
box.
Mineral buildup
or sediment
may have accumulated ]
in the old water
heater.
This causes the water /
__1_._
heater to be much heavier than normal and this|
residue, if spilled out, could cause staining.
]
7

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents