Instructions for Installation (cont'd)
Installation
Checklist
1. Whether or not the element conversion is made, the model
rating plate must be marked. Using a hard point ink pen,
HOT
___._[_
_
COLD
check the appropriate block within the model rating plate,
.
which is located adjacent to the lower access panel.
2. Is the fuse or circuit breaker size correct as shown in the
chart in the "Product Specifications" section?
CONDUIT _
v
J_
3. Are the wires from the circuit breaker or fuse service to the
_
TEMPERATURE-
water heater's junction box on the correct wire size (gauge)
as
_
J
PRE!;URE
RELIEI
shown in the chart in the "Product Specifications" section?
q
/
4. Is the new temperature-pressure
relief valve properly
installed, and piped to an adequate drain? See
"Temperature-Pressure
Refief Valve" in the "Instructions
--DISCHARG
(Donot c Ip or
for Installation" section,
plug
5. Is the water heater completely fdled with water? See
"Filling the Water Heater" instructions in the "Instructions
for Installation" section.
6. Will a water leak damage anything? See "Locating the
/
New Water Heater" in the "Instructions for Installation"
[
- ['-'-
section.
_
6"AIRG¢
7. Are the cold and hot water fines connected to the water
x_ _"
_
i
r
heater correctly? See "Water Piping" instructions in the
_
FLOOR DRAIN
"Instructions for Installation" section.
8. Is there adequate clearance for maintenance around the
water heater?
ELEC'FRIC W ATERHEATER
_o
m ogwmwcm_
_
Ik1"rAl.LE¢
9. Do you need to call your electric company to check your
,_,,_,_
_
(_
wiring?
I
I
] I I I
® Maytsgis a Tr =:bonerk of_
Co'potation and
ksusedI_
L_
to S_
Irl_str k_, Inc
MODEL RATING PLATE
17