Table of Contents
Advertisement
*9 For details on the input signal available for the multi
display, see "For the multi display" (page 42).
*10 The signal cannot operate with PRESET 7 and 8 (see
page 40).
*11 The signal can only operate with PRESET 1 (see page 40).
Rear Panel
a
/I (Equipotential/Function Earth) terminal
(equipotential) terminal
Connects the equipotential plug.
I (function earth) terminal
Connects the earth cable.
b COMPOSITE IN connector (BNC)
Input connector for composite signals.
c Y/C IN connector (4-pin mini-DIN)
Input connector for Y/C signals.
d G/Y IN connector (BNC)
Input connector for G of RGB signals and component Y
(luminance) signals.
e B/P
IN connector (BNC)
B
Input connector for B of RGB signals and P
difference) of component signals.
f R/P
IN connector (BNC)
R
Input connector for R of RGB signals and P
difference) of component signals.
16
Location and Function of Parts and Controls
*12 The signal can only operate with PRESET 6 (see page 40).
*13 When a BKM-256DD is installed, the number of the
input connector is increased.
*14 When a BKM-250TG is installed, the signal can be input.
g EXT SYNC IN (external sync input) connector
(BNC)
When this unit operates on an external sync signal,
connect the reference signal from a sync generator to
this connector.
To use the external sync signal, press the function button
that EXT SYNC is assigned (F1 button at the factory
setting).
Note
When inputting a video signal with the jitters, etc. the
picture may be disturbed. We recommend using the
TBC (time base corrector).
h Loop-through output connectors
Outputs the signals input to the input connectors (2 to
(blue color
7). Connect to the analog input (composite, Y/C,
B
analog component, analog RGB or external sync) of
equipment, according to the input signal.
When a cable is connected to one of these connectors,
(red color
R
the 75-ohm termination of the corresponding input is
automatically released, and the signal input to the input
connector is output.
Advertisement
Table of Contents
