Table of Contents
Advertisement
DISPLAY LAYOUT
Press the button to set DISPLAY LAYOUT when the
multi display is on. The mode switches in the sequence
POP t PIP t SIDE BY SIDE with every press of the
button (see "DISPLAY LAYOUT" on page 30).
SUB INPUT SELECT
Press the button to set the sub display input signal types
when the multi display is on. The mode switches in the
sequence COMPOSITE t Y/C t RGB t
COMPONENT t HD15 t DVI t OPTION A-1 t
OPTION A-2 t OPTION B-1 t OPTION B-2 t
VIDEO WAVE with every press of the button (see "SUB
INPUT SELECT" on page 31).
POSITION
Press the button to set the sub display position when the
PIP or POP multi display is on. The mode switches in
the sequence when POP is selected: 1 (Top) t 2
(Center) t 3 (Bottom), when PIP is selected: 1 (Bottom
left) t 2 (Bottom right) t 3 (Top right) t 4 (Top left)
with every press of the button.
FRAME
Press the button to set the main display position when
the POP multi display is on. The mode switches in the
sequence RIGHT t LEFT with every press of the
button.
SUB PICTURE SIZE
Press the button to set the size of the sub display when
the PIP multi display is on. The mode switches in the
sequence 1 (Small) t 2 (Large) with every press of the
button.
I/P MODE
Press the assigned button to set the delay by the picture
processing to the minimum level when interlace signal is
input. The mode switches in the sequence INTER-
FIELD t FIELD MERGE t LINE DOUBLER with
every press of the button (see "I/P MODE" on page 29).
MIRROR IMAGE
Press the assigned button to flip and display the video
signal horizontally. This function is not available for the
PRESET 1 signal and the multi display.
MONO
Press the assigned button to display a monochrome
picture. When the buttons is pressed again, the monitor
switches automatically to color mode.
32
Adjustment Using the Menus
APA (Auto Pixel Alignment)
Press to adjust the picture automatically to maximum
clarity for the signal input to the HD15 input connector.
For finer according to the input signal, see "DOT
PHASE" on page 28.
When the menu screen or the multi display is displayed,
APA does not function.
Note
If the APA operation does not finish correctly depending
on the input signal, adjust DOT PHASE (page 28).
BLUE ONLY
Press the assigned button to eliminate the red and green
signals. Only blue signal is displayed as an apparent
monochrome picture on the screen. This facilitates
"chroma" and "phase" adjustments and observation of
signal noise.
FLICKER FREE
Press the button to change the FLICKER FREE setting.
An OLED panel can provide superior video
responsiveness and scan driving, reproducing images
with little contouring or afterimaging. However, scan
driving can cause flicker when input signals have a low
vertical frequency (24P/PsF, 50I, etc.). Set FLICKER
FREE to ON to greatly reduce this phenomenon.
With this mode set to ON, quick-moving images may
exhibit contours or an afterimage.
Scan mode image
4
4 :3
1440 × 1080
4
1728 × 1080
16
9
3
16:9
1920 × 1080
16
3
9
1920 × 1080
Advertisement
Table of Contents
