Lock Light - GE JSP50GN Use And Care Manual

Operating the Self-Cleaning Oven
Delay
How to
Start Cleaning
Delay Start is setting the oven
timer to start the clean cycle
automatically at a later time than
NOTE: Before beginning, make
sure the oven clock shows the
correct time of day.
Quick Reminder—Delay
Start for Self-Clean:
1. Prepare oven for cleaning.
2. Slide the latch handle to the
right as far as it will go.
3. Push the STOP TIME button.
4. Set the desired time you
want the oven to stop. Turn
SET knob clockwise until the
Stop Time you desire appears
in the display.
5. Push the CLEAN button.
6. Turn the SET knob 1/2 turn.
Time that appears is 3X hours
self-clean cycle will
automatically begin 37? hours
select.
36
(continued)
For example: Let's say it's 7:00 and
you want the oven to begin self-
cleaning at 10:30 after you're
finished in the kitchen. The oven
is just soiled a normal amount so
the normal Clean Time of 3 'X hours
is preferred.
,
Step 2: Close the oven door and
make sure the oven light is off.
Slide the latch handle to the right
as far as it will go.
Step 3: Push STOP TIME button.
Step 4: Turn the SET knob to the
time of day when you wish
cleaning to be completed (must be
more than 3X hours later than the
current time of day).
Step 5: Push the CLEAN button.
Step 6: Turn the SET knob in a
clockwise direction about 1/2 turn.
The control automatically sets the
Start Time by adding the Clean
-
Time to the time of day. In this
example, the time of day is 7:00
and the Clean Time is 3 y? hours.
Adding 3 k hours to the time of
day equals 10:30.
The words "DELAY CLEAN" will
be on the display until the clean
cycle starts. After the clean cycle
starts, the words "CLEAN LOCK"
will be on the display.
I
Step 7: When the word "LOCK" is
off in the display, and the oven has
cooled, slide the latch handle to the
left as far as it will go and open the
oven door.
Never force the latch handle.
Wait until the word "LOCK"
goes out in the display. Forcing
the latch handle may damage the
door lock.
NOTE: During a delayed
self-clean operation, you can find
out when the oven will begin the
self-clean cycle by pushing and
holding the CLEAN button.
To Stop a Clean Cycle
Step 1: Press the CANCEL button.
Step 2: Wait until the oven has
cooled below locking temperature
(about 20-30 minutes) and the
word "LOCK" is off in the display.
You will not be able to open the
door right away unless the oven
temperature is at a safe level.
If "F-" and a number flash
on display and the control
beeps, this indicates function
error code. Press CLEAWOFF
pad. Allow oven to cool for one
hour. Put oven back into
operation. If function error
code repeats, disconnect power
to the oven and call for service.
—
I