GE JBP79 Use And Care & Installation Manual page 35

2. Muminum Wiring
range terminal block.
B. Spfice copper wires to aluminum wiring using
special connectors designed and U.L. approved
for joining copper to aluminum, and follow the
connector manufacturer's recommended
procedure closely.
splices, etc., must conform to good wiring
practice and local codes.
STEP 5
SPECIAL GROUNDING INSTRUCTIONS
Frame grounded to neutral of appliance
through a fink. E used in a MOBILE HOME or
if LOCW CODES do not permit grounding
through the neutral:
1) disconnect the link from neutral,
2) use grounding terminal or lead to ground
unit in accordance with local codes, and
3) connect neutral terminal or lead to branch
circuit in usual manner.
(If the appliance is to be connected by
means of a cord set, use 4-conductor cord
STEP b
ANTI-TIP BRACKET INSTALMTION
for instigation in a variety of locations. The
instructions include a template, a parts list and a
list of tools necessary to complete the instillation.
Read the IMPORTNT SN~ INSTRUCTIONS
and the instructions that fit your situation before
beginning instillation.
WARNING
1. Range must be secured by ~TI-TIP bracket
supplied.
2. See instructions to install (supplied with
bracket).
3. Unless properly installed, range could be
tipped by stepping or sitting on door. Injury
might result from spilled hot liquids or from
range itseti.
STEP 7
LEVELING THE RANGE
The range must be level. Leveling feet are located
at each corner of the base of the range. Remove
the storage drawer or kick panel (depending on
your model) and using channel locks, rotite the
leveling feet in and out as required to level the
range. (For instructions on how to remove and
replace the storage drawer or the kick panel, see
the Cleaning Under the Range section in Care
and Cleaning.) On some models, there are plastic
covers which may be removed for easy
adjustment oust squeeze and pull).
One of the rear leveling feet will engage the
adjustment). Nlow a minimum clearance of 1/8
inch between the range and the leveling foot that
GROUND
is to be installed into the NTI-TIP bracket.
LUG
Check the range for proper installation into the
properly installed) by removing the kick panel or
storage drawer and inspecting the rear leveling
leg. Make sure it fits securely into the slot.
STEP 8
FINAL CHECK
Be sure all switches are in the OFF position
before leaving the range.
Typical installation of Anti-Tip bracket
Attachment to Wall
Bracket
35