GE JBP79 Use And Care & Installation Manual page 33

BEFORE YOU BEGIN
Read tiese instructions completely
and carefu~y.
the lod electrical inspectors use.
CODES AND ORDINANCES.
NOTE TO INWWR: kave tiese
instructions titi tie appfimce *r
Care Guide and Instigation Instructions for
future use.
I
Channel lock phers or small ratchet wrench
l/4-inch hex head nutdriver
DO NOT USE AN -NSION CORD -
THIS APPUCE.
This appfiance must be suppfied with the proper
voltage and frequency, and connected to an
protected by a circuit breaker or time delay fuse, as
noted on the rating plate.
Wiring must conform to National Electic Codes.
above spectications, it is recommended that a
range is in position, flexible service conduit or cord
must be used.
STEP 1
PREPARE THE OPENING
to adjacent vertical walls above cooktop surface.
surface units and bottom of unprotected wood or
metal top cabinet, and 15 inches minimum
between countertop and adjacent cabinet bottom.
oven or cooking appfiance over tie cooktop shall
conform to the initiation instructions packed
with that appfiance.
To efirninate the risk of burns or tie by reaching
over heated surface units, cabinet storage space
above the surface units should be avoided. H
cabinet storage is to be provided, the risk can be
reduced by instalhng a range hood that projects
of the cabinets. Make sure the wdl coverings,
I
countertops and cabinets around the range, oven
or cooktop can withstand heat generated by the
I
range up to 200°E ~o~ ~~~~ ~HA~
I
I
I
WALL
1 %"
MIN.
OUTLET BOX
ON EITHER
SIDE OF Q
OUTLET
BOX
Anti-Tip Bracket ~
(install in either rear corner)
WITHIN EITHER
I
OF RANGE
/'
. . . . .
(continued nmt Page)
I
33