Rear Panel - Behringer MiniFex FEX800 User Manual

MINIFEX FEX800
The IN/OUT button enables/disables the effect signal. The button lights up when the input
signal is being processed by the FEX800. In order to hear the processed signal you have to set
a suitable ratio of effect vs. direct signal using the MIX BALANCE control
Use the OUTPUT LEVEL control to adjust the output level.
The switch turns your MINIFEX FEX800 on and off. The switch lights up when the unit is
switched on.
+
Fig. 2.2: Rear panel connectors of the FEX800
The FEX800 is connected to the mains using a 2-pole POWER connector jack. A matching
mains adaptor is included with the unit.
+
A single footswitch can be connected to the IN/OUT connector. This footswitch allows you
to remotely control the IN/OUT button
and off.
The two OUTPUT connectors are on 1/4" connectors and provide a balanced left/right signal.
The two INPUT connectors are on 1/4" connectors and can be used for unbalanced signals.
A single mono signal should be connected to the L jack.
SERIAL NUMBER.
8
2. CONTROL ELEMENTS AND CONNECTIONS

2.2 Rear panel

on the front panel and switch the effect signal on
.