Control Elements And Connections; Front Panel - Behringer MiniFex FEX800 User Manual

2. CONTROL ELEMENTS AND CONNECTIONS

Fig. 2.1: Front panel control elements of the FEX800
The two LED displays show the effect preset currently selected. One LED is assigned to each
preset.
+
Use the PRESETS control to select one of the 16 effect presets.
The EDIT control allows you to edit one effect parameter. The center position corresponds to
the default setting programmed for the preset.
+
The TAP/SELECT button performs two functions:
s Hit the button several times in the tempo of the music piece to adapt the
delay time of presets 9 and 15 or the modulation speed of presets 10-12. The button starts
flashing in the corresponding tempo.
s
effect characteristics when using presets 1-8, 13-14, 16. When the button lights up this means
that the corresponding parameter of the selected preset has been activated.
+
Use the INPUT LEVEL control to adjust the input signal level. Please be sure to set a level that
is sufficiently high but does not overload the unit.
The L+R LED display is for monitoring the input level. It comprises 6 LEDs. When the CLIP
LED lights up, this indicates that digital distortion may occur at the input of the FEX800. In this
case, the input signal level must be reduced.
Use the MIX BALANCE control to adjust the ratio of original vs. effect signal. Turn the control
fully to the right to hear only the processed effect signal. Turn it fully to the left to hear only the
unprocessed input signal.
2. CONTROL ELEMENTS AND CONNECTIONS

2.1 Front panel

Press this button to choose between two different
MINIFEX FEX800
7