Operation Mode Selection - GE AS0CD09 Owner's Manual & Installation Instructions

How to use the Operation Mode Selection button.
A
Auto Operation
El
Press the Start/Stop button. The unit will respond with a beep.
~ Open the door on the remote control. To select auto opemtion, press the Operation Mode Selection
Each time the button is pressed, the operation 'mode is s&fted in th; arrow direction.
"E!!wM3E!!3
Cooling Auto
Dehumidify
Heating (Heat pump only)
H
The temperature and fan speed are
automatically set by the electronic controls
based on the actual room tempemture. lfyou
want to change the set tempemture, close the
door on the remote control and press the Room
Tempemture Setting buttons. The cooler or
warmer you feel, the more times (up to two
times) you should press the button. The set
tempemture will then be changed automatically.
l)uring Auto Operation:
.' You cannot switch the indoor fim speed. It has
already been set by the electronic control.
. If the system is not operating as desired,
manually switch to another mode. The system
will not automatically switch from the cooling
mode to the heating mode, or from heating to
cooling, it must be done manually. Reset using
the Operation Mode Selection button.
L__l
Q A
' During Auto Operation, pressing the Airflow
"g
1A
@
To raise the
Direction Start/Stop button makes the horizontal
temperature
louvers swing up and down automatically. Ifyou
---r V
want to stop auto-swin
To lower the temperature
%
press
the
Airflow
Direction Start/Stop button again.
8
()
Dehumidi@ Operation
pJ
Press the Start./Stop button. The unit will respond with a beep.
Openthedoorontheremotecontrol.To selectdehumi@operation, presstheOperationMode
Selection button. Each time the button is pressed, the operation mode is shifted in the arrow direction.
(==--)
\/l—
[ I )
[
I
) (
I
J
Cooling Auto
Dehumidify Heating (Heat pump only)
1
J
Close the door on the remote control. Set the During l)ehumid~ Operation:
tempemture higher than the room
'~ ~The indoor fim speed is automatically set to low
tempemture. The temperature can be setwithin
and cannot be adjusted.
a m.nge of 64° F–86° Fin 2° F increments.
I
' The indoor fim may stop during this opemtion if
the electronic control detects over=cooling.
J*
&
To caisethe
temperature
v
To lower the temperature