Table of Contents
Advertisement
3
Operation & Installation
Installation-Speed Governor
Installation-Relay
Installation-Acc Detecting
Installation-Fuel Monitoring(option)
Installation-Speed governor
1) Find a place under the accelerator pedal, and drill a hole, install and fix the governor, and then
adjust the distance between accelerator pedal and governor accordingly, the shortest distance to
governor is 0.5-1cm when floor the pedal.
2) Fix the governor, get a iron rod and pass through the hole at the buttom of governor (point A),
and weld the iron rod to the car.
Diagram-speed governor
1). Connect black cable of controller to power I/O
cable of tracker (GND,black).
2). Connect red cable of controller to power I/O
cable of tracker (positive, red)
3). Connect yellow cable of governor controller to
power I/O cable of tracker (yellow,OUT1).
ONER GPS Vehicle Tracker
User Manual
Operation & Installation
5
Advertisement
Table of Contents
