Getting Started - TRENDnet TEW-821DAP User Manual

TRENDnet User's Guide

Getting Started

For a typical wireless setup at home or office when using the access point in AP mode,
please do the following:
Installation
1. Connect the power adapter to the power port of the access point. Or simply plug an
Ethernet cable on the access point to a PoE (Power over Ethernet) switch that
connects to your router or network.
2. If using the power adapter, plug an Ethernet cable to the access point and plug the
other enf to your router or network.
3. Verify that all LEDs are on.
4. For your security, each TEW-821DAP comes pre-encrypted with a unique WiFi Name
(SSID) and WiFi Password. You can find your device's SSID and WiFi password on the
white labels located on the device. Use this information to connect to the TEW-
821DAP access point.
5. Verify your connection to you network by accessing the Internet. For advanced
configuration continue to the advanced sections of the user manual.
© Copyright 2015 TRENDnet. All Rights Reserved.
Mounting device
1. Remove the mount plate from the access point.
2. Place the mounting plate on the wall or ceiling where the device will be located and
mark the location of the screw holes. Ensure that the device has enough clearance to
slide on and off the mounting plate.
3. Drill out the marked holes and insert the plastic wall anchors in to the wall.
4. Secure the mounting plate using the screws that came with the device.
TEW-821DAP
7