Table of Contents
Advertisement
TRENDnet User's Guide
Getting Started
For a typical wireless setup at home or office when using the access point in AP mode,
please do the following:
Installation
1. Plug an Ethernet cable on the access point to a PoE (Power over Ethernet)
switch/injector that connects to your router or network.
2. Verify that the LED is on.
4. For your security, each TEW-921DAP comes pre-encrypted with a unique WiFi Name
(SSID) and WiFi Password. You can find your device's SSID and WiFi password on the
white labels located on the device. Use this information to connect to the TEW-
921DAP access point.
5. Verify your connection to you network by accessing the Internet. For advanced
configuration continue to the advanced sections of the user manual.
Mounting device
© Copyright 2017 TRENDnet. All Rights Reserved.
To mount the access point, first route the network cable through the largest opening in
the mounting plate and install the mounting plate to the desired wall or ceiling using the
included drywall anchors and screws. Install the mounting plate with the correct
orientation. After the mounting plate is properly installed, connect the network cable to
the network LAN port of the access point, align the access point mounting holes with
the mounting plate clips and rotate the access point clockwise to lock into place. Finally,
install the cable guard by sliding it onto the mounting plate until it locks into place.
TEW-921DAP
5
Advertisement
Table of Contents
