General Information; Preparation Before Installation - Intermec EasyCoder 201 II Installation Instructions

EasyCoder 201 II – Installation Instructions
LABEL-TAKEN SENSOR KIT

General Information

Preparation Before
Installation
EasyCoder 201 II
Label-Taken Sensor Kit
Installation Instructions
Edition 3, September 1998
Part No. 1-960255-04
This booklet contains instructions on how to install the Label-
Taken Sensor Kit (LTS) on an EasyCoder 201 II printer. Installa-
tion should preferably be performed by an authorized service
technician.
For instructions on how to use the label-taken sensor, please refer
to the EasyCoder 201 II Technical Manual.
The Label-Taken Sensor kit consists of:
• 1 Reflecting Sensor assy. with bracket and cable
• 1 Screw
• This Installation Instructions booklet.
The status of the LTS has to be polled in the Intermec Fingerprint
program by means of the
will not react on the LTS signal.
Make a simple program that checks the printer's status, e.g.:
10 BREAK 1,88
20 BREAK 1 ON
30 FORMFEED
40 IF (PRSTAT AND 2) THEN BEEP
50 GOT0 40
60 END
RUN
You can break this program by transmitting the character X
(ASCII 88) decimal on the standard serial interface "uart1:".
Information in this manual is subject to change without prior notice and does not
represent a commitment on the part of Intermec Printer AB.
© Copyright Intermec PTC AB, 1998. All rights reserved. Published in Sweden.
EasyCoder and Fingerprint are registered trademarks of Intermec Technolo-
gies Corp.
function, as otherwise the printer
PRSTAT
1