Intermec EasyCoder 201 II Installation Instructions
Label-taken sensor kit
Hide thumbs
Also See for EasyCoder 201 II:
- Technical manual (95 pages) ,
- Startup manual (21 pages) ,
- Supplementary manual (14 pages)
Related Manuals for Intermec EasyCoder 201 II
Summary of Contents for Intermec EasyCoder 201 II
- Page 1 Installation Instructions P/N 1-960255-04 Edition 3 September 1998 EasyCoder 201 II Label-Taken Sensor Kit...
-
Page 2: General Information
• 1 Reflecting Sensor assy. with bracket and cable • 1 Screw • This Installation Instructions booklet. Preparation Before The status of the LTS has to be polled in the Intermec Fingerprint Installation program by means of the function, as otherwise the printer PRSTAT will not react on the LTS signal. - Page 3 EasyCoder 201 II – Installation Instructions LABEL-TAKEN SENSOR KIT, cont'd. Step-by-Step Installation Turn off the power and remove the power cord. Instructions Disconnect all communication cables. Open the right-hand door. Loosen the two screws that lock the cover. Pull the cover straight back and remove it completely.
- Page 4 EasyCoder 201 II – Installation Instructions LABEL-TAKEN SENSOR KIT, cont'd. Step-by-Step Installation Remove the two screws that hold the front moulding. Instructions, cont'd. Original Screw Front Moulding Cable New Screw (incl. in the kit) LTS assy. Carefully manipulate the moulding so you can slip the cable of the label-taken sensor through the gap between the moulding and the centre-line wall of the printer.
- Page 5 EasyCoder 201 II – Installation Instructions LABEL-TAKEN SENSOR KIT, cont'd. Step-by-Step Installation Fit the cable from the label-taken sensor to connector P-8 at the Instructions, cont'd. lower, front part of the CPU board. WARNING! To avoid the risk of short-circuits, use...