Grandstream Networks GXP1610 Administration Manual page 32

Mute Key Functions
While Idle
Disable Transfer
In-call dial number on
pressing transfer key
Auto-Attended Transfer
Do Not Escape #
as %23 in SIP URI
Click-To-Dial Feature
Call History Flash
Writing:
Write Timeout
Call History Flash
Writing:
Max Unsaved Log
Settings ->Multicast paging
Paging Barge
Paging Priority Active
Multicast Paging Codec
Multicast Listening
Settings -> Ring Tone
Call Progresses Tones:
System Ring Tone
Dial Tone
Second Dial Tone
Message Waiting
Ring Back Tone
Call-Waiting Tone
Busy Tone
Reorder Tone
Call Waiting Tone Gain
Settings -> Audio Control
Headset Key Mode
When set to "DND", the DND will be enabled for future incoming call if pressing
MUTE key in idle state; If this feature is set to "Idle Mute", MUTE key will take
effect in idle state and future incoming call will be answered with mute;
Otherwise, MUTE key will not take effect in idle state.
Disables the Transfer function. The default setting is "No".
Configures the number for the phone to dial as DTMF during the call using
TRAN button.
If set to "Yes", the phone will use attended transfer by default. The default
setting is "No".
Specifies whether to replace # by %23or not for some special situations. The
default setting is "No".
Enables Click-To-Dial feature. The default setting is "Disabled".
Defines the interval (in seconds) to save the call history to phone's flash. The
default value is 300 seconds.
Defines the number of unsaved logs before written to phone's flash. The
default value is 200 entries.
During active call if incoming multicast page's priority is higher than this value,
the call will be held and multicast page will be played.
If enabled, during a multicast page if another multicast is received with higher
priority, that one will be played instead.
The codec for sending multicast pages, there are 7 codecs could be used:
PCMU, PCMA, G.723.1(pending), G.726-32, G.729A/B, G.722(wide band).
The default setting is "PCMU".
Defines multicast listening addresses and labels. GXP16xx phone can listen to
at most 10 multicast addresses with different priorities.
Configures ring or tone frequencies based on parameters from local telecom.
The default value is North American standard. Frequencies should be
configured with known values to avoid uncomfortable high pitch sounds.
Syntax: f1=val,f2=val[,c=on1/off1[-on2/off2[-on3/off3]]];
(Frequencies are in Hz and cadence on and off are in 10ms)
ON is the period of ringing ("On time" in 'ms') while OFF is the period of silence.
In order to set a continuous ring, OFF should be zero. Otherwise it will ring ON
ms and a pause of OFF ms and then repeat the pattern. Up to three cadences
are supported.
Configures the call waiting tone gain to adjust call waiting tone volume. The
default setting is "Low".
When headset is connected to the phone, users could use the HEADSET
button in "Default Mode" or "Toggle Headset/Speaker".

Default Mode:
 When the phone is in idle, press HEADSET button to off hook the
phone and make calls by using headset. Headset icon will display on
the screen in dialing/talking status.
 When there is an incoming call, press HEADSET button to pick up the
call using headset.
GXP1610/GXP1620/GXP1625/GXP1628/
GXP1630 Administration Guide
Page 31 of 52