Placing Originals; Original Orientation - Ricoh VD0107571 Operating Instructions Manual

Placing Originals

This section describes the procedure for placing originals on the exposure glass
and in the ARDF.
Take care to place originals after any correction fluid and ink has completely
dried. Not taking this precaution could cause marks on the exposure glass that
will be copied onto paper.
Reference
p.7 "Originals"

Original Orientation

You can set the original orientation in the following ways.
This function is useful for copying torn or large originals.
Originals ARDF
Note
❒ Originals should normally be aligned to the rear left corner. However, some
copy functions may produce different results depending on the orientation of
the originals. For details, see the explanations of each function.
Reference
p.50 "Staple"
p.52 "Duplex"
p.55 "One-Sided Combine"
p.59 "Two-Sided Combine"
p.62 "Series Copies"
Exposure
glass
set11EE
set23EE
Placing Originals
1
11