Denon AVR-1610 Owner's Manual page 26

ENGLISH
Making the Optimum Settings for the Connected Speakers Automatically (Audyssey Auto Setup)
Error Messages
Restore
3-2. Parameter Check
Distance Chenck
Channel Level Check
Crossover Freq. Check
EQ Check
[ENT] :Select [RTN] :Back
Use
t::. V
to select the item you want to check, then
press
8.
Speaker Config. Check
Check the speaker configuration
Distance Check
Check the distance
Channel Level Check
Check the channel level
Crossover Freq. Check
Check the crossover frequency
EO Check
Check the equalizer
Use
<3 I>
to switch the display between the different
speakers.
Check Audyssey Auto Setup
Measurement Results (Parameter Check)
This is displayed after the Audyssey Auto Setup procedure is
completed.
1
Press
t::. V
to select
"Parameter Check",
then press
8.
"Parameter Check" is
displayed on the on-screen
display.
2
3
Measures
• Connect the included setup microphone to the
SETUP MIC jack on the main unit.
• Check the speaker connections.
• Either turn off any device generating noise or
move it away.
• Try again when the surroundings are quieter.
• Check the speaker installation and the direction
in which the speakers are facing.
• Adjust the subwoofer's volume.
• Check the connections of the displayed
speaker.
Cause
• Not all speakers could be detected.
• The front L speaker was not properly detected.
• Included setup microphone is not connected.
• Too much noise in the room for accurate
measurements to be made.
• Speaker or subwoofer sound is too low for
accurate measurements to be made.
• Displayed speaker could not be detected.
· The front R speaker were not properly detected.
Only one channel of the surround speakers was
detected.
Sound was output from the R channel when only
one surround back speaker was connected.
· The surround back, but the surround speaker was
not detected.
ElTOr messages (examples)
Mu
I
I EQ
ReI r y
Cancel
Ski p
[.~] : Up/Down [.~]: CH
ReI r y
Cancel
[ENT] :Relry
Caution
If the Audyssey Auto Setup procedure could not be completed due to speaker installation, the measuring environment, etc., an error message is
displayed. If this happens, check the relevant items, be sure to take the necessary measures, then perform the Audyssey Auto Setup procedure
over again.
-n.h8
Be sure to turn the power off before checking the speaker connections.
I
o
To perform the Audyssey Auto Setup procedure again
Press
t::.
\l to select "Retry'; then press
8.
Even if the settings are changed after the Audyssey Auto Setup
procedure, the Audyssey Auto Setup settings can be restored by
selecting" Restore" then pressing
8.
Caution
Mu It E
ReI r y
Cancel
Skip
[.~] : Up/Down [.~]: CH
• Displayed speaker connected with the polarities
reversed.
• Check the polarities of the displayed speaker.
• For some speakers, this error message may
be displayed even if the speaker is properly
connected. If you are sure that the wiring is
correct, press
t::.
\l to select "Skip '; then press
8-
4
Press
~N'
The confirmation screen reappears. Repeat steps 2 and 3.
o
To cancel Audyssey Auto Setup
Use
t::.
\l to select" Cancel ': then select" Yes" using
<11>.
23