Loading The Multipurpose Feeder - Lexmark C925 Quick Reference

3
Squeeze and then slide the length guide to the correct position for
the paper size you are loading.
4 Flex the sheets back and forth to loosen them. Do not fold or crease
the paper. Straighten the edges on a level surface.
5
Load the paper stack with the recommended print side faceup.
Notes:
• If the paper is longer than A4, then load it in short‑edge
orientation.
•
If the paper is shorter than A4, then load it in long‑edge
orientation.
• Make sure the paper is below the maximum fill line located
on the edge of the paper tray. Overloading the tray can
cause paper jams and possible printer damage.
Long‑edge orientation Short‑edge orientation
6
Adjust both the width and length guides to lightly touch the edge
of the paper stack. Make sure the paper fits loosely in the tray, lies
flat, and is not bent or wrinkled.
7
Turn the wheel clockwise to set the paper size.
5
8
Lock the width guide.
9
Insert the tray.
10
From the printer control panel, verify the Paper Size and Paper Type
for the tray based on the paper you loaded.

Loading the multipurpose feeder

The multipurpose feeder can hold several sizes and types of print
media, such as transparencies, labels, card stock, and envelopes. It can
be used for single-page or manual printing, or as an additional tray.
The multipurpose feeder can hold approximately:
• 2
50 sheets of 75‑g/m (20‑lb) paper
•
10 envelopes
•
20 transparencies