Grandstream Networks GXP1100 User Manual page 40

Enable Idle Mute
Disable Transfer
In-call dial number on pressing
transfer key
Auto-Attended Transfer
Do Not Escape # as %23 in
SIP URI
Click-To-Dial Feature
Blink message LED on ringing
Call History Flash Writing:
Write Timeout
Call History Flash Writing:
Max Unsaved Log
Enable FLASH Key as CONF
Settings -> Multicast Paging
Paging Barge
Paging Priority Active
Multicast Paging Codec
Multicast Listening
Settings -> Ring Tone
Call Progresses Tones:
System Ring Tone
Dial Tone
Second Dial Tone
Message Waiting
Ring Back Tone
Call-Waiting Tone
Busy Tone
Reorder Tone
FIRMWARE VERSION 1.0.8.4
If this feature is enabled, MUTE key will take effect in idle state and future
incoming call will be answered with mute.
Disables the Transfer function. The default setting is "No".
Configures the number for the phone to dial as DTMF during the call
using TRAN button.
If set to "Yes", the phone will use attended transfer by default. The default
setting is "No".
Specifies whether to replace # by %23 or not for some special situations.
The default setting is "No".
Enables Click-To-Dial feature. The default setting is "Disabled".
Message LED light will blink if there is an incoming call.
Defines the interval (in seconds) to save the call history to phone's flash.
The default value is 300 seconds.
Defines the number of unsaved logs before written to phone's flash. The
default value is 200 entries.
If set to "Yes", the FLASH key can be used to establish 3-way
conference. The default setting is "No".
During active call if incoming multicast page is higher priority than this
value the call will be held and multicast page will be played. Note: 1 is the
highest value.
If enabled, during a multicast page if another rmulticast is received with
higher priority, that one will be played instead. Note: 1 is the highest
value.
The codec for sending multicast pages.
Defines multicast listening addresses and labels.
Configures ring or tone frequencies based on parameters from local
telecom. The default value is North American standard. Frequencies
should be configured with known values to avoid uncomfortable high
pitch sounds.
Syntax: f1=val,f2=val[,c=on1/off1[-on2/off2[-on3/off3]]];
(Frequencies are in Hz and cadence on and off are in 10ms)
ON is the period of ringing ("On time" in 'ms') while OFF is the period of
silence. In order to set a continuous ring, OFF should be zero. Otherwise
GXP1100/GXP1105 USER MANUAL Page 38 of 53