Installation Procedure; Install The Wall Plate On The Wall - Epson EB-465i Installation Manual

5. Installation Procedure

Make sure to follow the steps below to install the setting plate. If you ignore these steps, the setting plate
could fall and cause personal injury or property damage.
The maximum combined mass of the setting plate and the projector is approximately 15.2 kg
(33.5 lb). When you install the setting plate, calculate the permissible weight, carefully check
the construction, material, and strength of the wall, and perform the installation properly using
the most appropriate method.
A

Install the wall plate on the wall

(1) Determine the template sheet position.
• From the projection distance table, confirm the screen size (S) and the distance between the
projection surface and wall plate (b).
• Align the CTR line (vertical) of the template sheet with the center line (vertical) of the projection
surface.
Confirm where the beams are within the wall, and shift the position left or right as necessary.
(The position can be shifted horizontally left or right from the center line of the projection surface by
up to 45 mm [1.77 in.].)
Align the line (horizontal) of the template with the height of (b).
CTR line of template sheet
line of template sheet
(2) Attach the template sheet to the wall.
65 mm (2.55 in.)
Center line of projection surface
13