Panasonic Touchbook CF-17 series Reference Manual page 8

Touch Pad
(Advanced)
F u n c t i o n
*
P a n
Scroll in various directions of a
document
(move the mouse slightly while
holding down the wheel)
*
Z o o m
Magnify/reduce the display of
a document.
(rotate the wheel while holding
down )
Ctrl
*
Data Zoom
Display or hide a document, or
perform operations to return to or
proceed with Internet Explorer.
(rotate the wheel while holding
down )
Shift
W ithin the parentheses () are operations to follow when using an external Microsoft
TM
IntelliMouse .
*
Indicates that the movements will differ depending on the application.
CAUTION
When an external mouse or trackball with additional functions (e.g., wheel func-
tion) is connected, a part or all of the additional functions may foil to operate. To
use these additional functions, install the driver or application software of the
external device by following the procedure below. However, once the driver or
application software is installed, touch pad functions (e.g., auto scroll) may not
operate even if the touch pad is enabled (see the procedure for "When you want
to re-enable the touch pad.").
1 In [Control Panel] - [System] - [Device Manager], select [touch pad] in [Mouse],
press [Remove] to delete it, then press [OK] to confirm the deletion.
2 Power off your computer and connect the external mouse or trackball device to
the computer.
3 Turn the power on and run the Setup Utility (
[Touch Pad] to [Disable] and close the Setup Utility.
4 Following the operating instructions for the connected external mouse, install
the necessary driver.
After the installation, set [Touch Pad] to [Disable] in the Setup Utility.
Do not enter the suspend or hibernation mode when an external mouse is con-
nected to the serial port.
When you want to re-enable the touch pad;
1 In [Control Panel] - [System] - [Device Manager], when an external mouse or
trackball device is displayed in [Mouse], press [Remove] to delete it, and then
press [OK] to confirm the deletion.
2 Power off your computer and remove the external mouse or trackball device.
3 Turn the power on and run the Setup Utility (
[Touch Pad] to [Enable] and close the Setup Utility.
4 Confirm whether [touch pad] exists in [Mouse] (in [Control Panel] - [System] -
[Device Manager]).
Touch Pad Operation
W h e e l
Operate while holding down the two buttons.
W h e e l
+
Ctrl
W h e e l
Shift +
M a g n i f y
R e d u c e
page 37). In [Main] menu, set
page 37). In [Main] menu, set
(To next page)
8
®