Provisioning; General Configuration For Outbound Calling - Linksys PAP2 Installation Manual

Hide thumbs Also See for PAP2:

Table of Contents

Provisioning

To configure the PAP2 for outbound calling:

1. Connect to the PAP2 by entering the device's IP address in the Web browser's

2. Click on the Admin Login link in the upper right corner of the page, and then

3. Click the System tab, and in the Internet Connection Type section, click the

4. If you set DHCP to no, enter the Static IP, NetMask, and Gateway information.

5. Click the Submit All Changes button at the bottom of the page to save the

Address bar. For instructions on obtaining the IP address, refer to section 2.3

Accessing the PAP2 on page 2 in this Guide.

click the advanced configuration link.

PAP2 Web Interface – Main Window

DHCP drop-down menu, and select yes or no.

System Tab

If you set DHCP to yes, continue to step 5.

settings.

Page 4

Linksys PAP2 Installation Guide

Table of Contents