Parts And Functions - Haier HW-12C03 Service Manual

Parts and Functions

Inserting Dry Batteries
Two R-03
dry batteries
Note:
1) Use two new dry batteries of the same brand
and type.
2) When the remote controller is not active after
dry batteries have been replaced, press with a
thin stick the green-colored reset button which
is illustrated with a
3) If the wireless remote controller is not to be
used for a long period, the dry batteries should
be removed from the wireless remote controller.
Handing the Wireless Remote Controller
When operating, point the signal sending head toward the signal receiver of the unit.
Do not allow any obstacle between the signal sending head and the signal receiver.
Do not drop, throw or wet the wireless remote controller.
The signal receiver may not receive the signal in a room which has an electro-lighting
(rapidstart) type fluorescent lamp, an inverter-type fluorescent lamp or a cordless phone.
Reset Button
(green)
mark in the figure.
48
1
Remove the lid
Gently press the part indicated by
OPEN and slide the lid away from
the controller.
2
Insert the dry batteries
Make sure the dry batteries are set
in the right directions according to
the diagram in the cavity.
3
Attach the lid
4
Verify by the indicators
If displays do not appear when the
ON/OFF switch has been pressed,
set dry batteries once more.