Installation Instruction - Haier HW-12C03 Service Manual

Installation instruction
Selection of the installation position
1. Select position where the structure is firm.
2. Select position where the air inlet and outlet are smooth without obstacles.
3. Select position where the cooled air can be blown to every corner of the room.
4. Select position where there's no direct sunlight. If the sunlight is inevitable. sunshading device
is required.
5. Select position where the outdoor airflow will not influence the neighbors.
6. Select position where the drainage is smooth.
7. Select position where there's no dangerous gas or oil smoke nearby.
8. An extention cord is not recommened.
Installation diagram
It should be installed like this; the back side(outdoor side) is lower so that the drained water can
flow out smoothly.
Width of the wall should be
less than 295mm
Requirements on electricity:
Be sure to use specific power circuit.
1.Applicable ambient temperature range:
Indoor
Cooling
Outdoor
Indoor
Heating
Outdoor
If the ambient temp. is over 52 , the air-conditioner can also operate normally.
(For HW-18CC03, HW-24C03, HW-24CA03, HW-24C13, HW-24H03,AW242AQAAB,
HW-18CE03, HW222AAAAA, HW222AAMAA)
2. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or
a similar qualified person. An extend cord is not recommended.
3. The wiring method should be in line with local wiring standard.
4. After installation, the power plug should be easily reached.
Maximum: D.B/W.B
Minimum: D.B/W.B
Maximum: D.B./W.B.
Minimum: D.B
Maximum: D.B
Minimum: D.B
Maximum: D.B/W.B
Minimum: D.B/W.B
104
32 /23
18 /14
43 /26
15
27
15
24 /18
-7 /-8