Heat Operation - Haier HW-12C03 Service Manual

Heat operation

This function is only for heat pump.
1.Start
Press ON/OFF button
2.Select operation mode
Press the "MODE" button. Every time
the button is pressed, operation mode
changes in the following order.
AUTO COOL
Select "Heat" mode.
3.Fan speed selection
Press the FAN speed button. Every time it
is pressed, Fan speed changes as follows:
AUTO
Select desired fan speed. Change air
flow if necessary.
4.Stop
Press ON/OFF button again.
Note: This Auxiliary heat function is only
for AW-12eA03, AW-12eA04
Auxiliary Heat function
In Heating, if push Auxiliary Heat switch to ON
position, when room temperature is no more than
20 , after compressor has started for 1 minute,
Auxiliary Heat function starts; when room temperature
is over 25 or during defrosting, Auxiliary
Heat function stops. To cancel Auxiliary
heat function, just push to "OFF" position.
DRY
HEAT
HI LOW
For heat pump type
HW-12eA04
HW-12HA04
WIRELESS REMOTE CONTROL
53
TEMP
C
SLEEP TIMER
OFF
ON
HR
AUTO
COOL
MODE
DRY
HEAT
2
AUTO
FAN
HI
LOW
3
LOUVER
ON/OFF
4
1
POWER
TIMER OPERATION
ON OFF
Auxiliary Heat switch Emergency switch