Gigabyte GA-990FXA-UD5 R5 User Manual page 61

Step 5:
Usable hard drives are listed on the Logical Drive Create Menu. Use the up or down arrow key to select the
hard drive to be included in the array and press the <Space> key. The selected hard drives will be marked with
[X]. Then move to Basic Setting and press <Enter>.
RAID Utility (C) 2012 Advanced Micro Devices, Inc. [Rev. 1.0.0.45]
+ Logical Drive Create Menu
+ Usable Physical Drive List
- Hitachi HDT721032SLA360
- Hitachi HDT721032SLA360
+ Basic Setting
hi=Move Highlight
Step 6:
Use the up or down arrow key to move to and configure each required item in sequence.
After completing, press <Enter> on Start To Create (Figure 7). When the message "Are You Sure To Create
Logical Drive?" appears, press <Enter> to begin creating the RAID array or <Esc> to cancel.
RAID Utility (C) 2012 Advanced Micro Devices, Inc. [Rev. 1.0.0.45]
+ Logical Drive Create Menu
- Raid Mode :
- Stripe Block (KB) :
- Setcor Size (Bytes) :
- Initialization :
- Gigabyte Boundary :
- Read Policy :
- Write Policy :
- Ld Name :
+ Ld Size Setting
- Ld Max Size : 1000.21 GB
- Ld Size (GB) :
+ Start To Create
hi=Move Highlight
When completed, a message which says "Successful To Create Logical Drive" will appear. Press <Enter> to
complete. Press <F10> to exit the RAID setup utility.
| 500.10 GB [X]
| 500.10 GB [X]
<Space>=Toggle Checkbox
Figure 6
<RAID 0>
<64>
<512>
<Fast>
<Enable>
<Read Ahead>
<Write Back>
GBT
[0]
<Enter>=Select Option
Figure 7
- 61 -
Usable Physical Disk On
(Port : 4, TargetId : 1)
F10=Exit Utility
Esc=Previous Page
F10=Exit Utility
Esc=Previous Page
Configuring SATA Hard Drive(s)