Tangled Thread On Wrong Side Of Fabric; Symptom; Cause; Remedy - Baby Lock Destiny BLDY Instruction And Reference Manual

TROUBLESHOOTING
d
While holding the bobbin in place with
your finger, pass the thread through the slit
in the needle plate.
* Hold down the bobbin with your right hand, and
then pull the end of the thread around the tab with
your left hand.
a Tab
b Hold down the bobbin with your right hand.
Pull the thread to pass it through the slit in the
needle plate, then cut it with the cutter.
c Slit
d Cutter
Sewing with the correct thread tension is possible
after the bobbin has been correctly installed in the
bobbin case.
382
Tangled Thread on Wrong Side of
Fabric

■ Symptom

* The thread becomes tangled on the lower side of the
fabric.
* After starting sewing, a rattling noise is made and
sewing cannot continue.
* Looking under the fabric, there is tangled thread in
the bobbin case.

■ Cause

Incorrect upper threading
If the upper thread is incorrectly threaded, the upper
thread passed through the fabric cannot be firmly
pulled up and the upper thread becomes tangled in
the bobbin case, causing a rattling noise.

■ Remedy

Remove the tangled thread, and then correct the
upper threading.
a
Remove the tangled thread. If it cannot be
removed, cut the thread with scissors.
* Refer to "Cleaning the Race" in "CARE AND
MAINTENANCE" on page 376.
b
Remove the upper thread from the
machine.
c
Refer to the following steps to correct the
upper threading.
* If the bobbin was removed from the bobbin case,
refer to "Setting the Bobbin" on page 57 and
"Remedy" in the section "Upper Thread is Too
Tight" on page 381 to correctly install the bobbin.