Table of Contents
Advertisement
1. Introduction and Installation
4
Insert the blue gear of the ink film roll into the front
left slot of the unit (3) and the white gear of the ink
film roll into the rear left slot of the unit (4).
L The ink film is safe to touch and will not rub off on
your hands like carbon paper.
L Make sure the blue gear (3) and white gear (4)
are installed as shown.
3
5
Turn the blue gear (5) in the direction of the arrow
until the ink film is tight (6) and at least one layer of
ink film is wrapped around the blue core (7).
5
10
4
6
Correct
7
Incorrect
No ink film is wrapped around the blue core.
Slack/Crease
6
Close the back cover securely by pushing down on
the dotted area at both ends (8).
7
Close the front cover securely.
1 turn
Tight
Reverse
8
Advertisement
Table of Contents
