Calling From Co To Tie - Panasonic KX-T336200 Installation Instructions Manual

14.03 Calling from CO to TIE

Description
Employee-l
.
Programming example: To make up the TIE Line Network above, the following system programming is
PBX-1
TIE lines are usually used to link two or more distant locations where high
volume calling traffic exists. However, a person at a location outside of the Tie
Line Network can also use it by first making a CO call via public network to the
nearest point of TIE Line Network for the purpose of saving the toll call charge.
I
PBX Code 950
I
Call Flow
1. Employee-l at a local branch makes a CO call to PBX-1 via DISA.
2. Employee-l dials "84" (TIE trunk access code).
3. After hearing dial tone, Employee-l
4. Employee-l at a local branch will be connected to Ext.1 00 of PBX-2.
required at PBX-1 and -2 respectively.
System -Operation (l/3) (9-D-l .Ol , 10-C-4.00)
l
PBX Code: 950
Group - Trunk Group (2/2) (9E-1.02,1
l
CO-TIE Restriction: No'
This assignment is required at the trunk group whose
l
'Incoming Mode" is set to 'DISA".
Special Attended - TIE Line Routing Table
l
C o d e D e l e t e
No.
Digit
0 1 9 5 1 0
. .
3-F-79
(70695)
A Network of TIE Lines
TIE Line
Inside of the TlE tine Network
O-C-1 5.00)
Trunk Group Hunt Sequence
Insert
Dial 0 1 0 2
1 0 .
PBX-2
I
PBX Code 951
I
Ext. 100