Call Forwarding To Trunk - Panasonic KX-T336200 Installation Instructions Manual

2.05 Call Forwarding to Trunk

Description
Call Forwarding to Trunk allows extension users
who are away from their phones to receive
incoming calls (both CO and extension) at outside
p l a c e .
The following incoming calls do not receive Call
Forwarding treatment.
.
A call appearing on ICM button
l
A call from doorphone
l
A call appearing on PC0 button
l
A call routed via DIL 1: N feature
l
A call directed to a UCD group
l
When an incoming CO call is forwarded to the
pre-assigned outside party by this feature, CO to
CO call via this system is established. Duration
time of CO to CO call is restricted by "Group-
Trunk Group," CO-CO Duration Limit of receiving
CO line. The system sends alarm tone to both
parties 15 seconds before the Duration Limit time
is expired, and when expired the system
disconnects both parties compulsively.
To set Call Forwarding to Trunk, assign both
"System-Class of Service", Call Forwarding/Do
Not Disturb and CO forward Mode to "Yes."
For setting and canceling this function, two
methods are available:
"Call Forwarding-to Trunk' and
'Call Forwarding/Do Not Disturb Cancel."
Programming
System Programming
'System-Class of Service (l/2)
Forwarding/Do Not
Call
Disturb
CO Forward Mode
"System-Numbering Plan
Call Forwarding-to
'System-Numbering Plan
Call Forwardinq/Do Not
Disturb Cancel
"Group-Trunk Group (l/2)",
CO-CO Duration Limit
Conditions
To set or cancel this function, use the PDN button.
An extension user may have only one type of Call
Forwarding/Do Not Disturb feature in effect at any
time. If a second type is assigned, the previously
assigned type is canceled.
The Operators (Attendant Console or Extension)
can cancel the Call Forwarding/Do Not Disturb
feature assigned to the extension users. Refer to
Section 4-l-11 .OO 'Remote Station Feature
Control."
Up to 32 digits composed of '0 through 9" and
the destination. CO line access code must be
entered as the leading digit of each entry.
Note:
If CPC signal is not supplied by the Central
l
Office in your area, KX-T336 cannot detect the
end of CO-CO call after one party disconnects
the call.
In this case, we recommend to use tone
detection feature of AGC Card (See Section 1
C-67.00 'DISAIAGC Tone Detection Mode
4-F-l 8
(70695)
9-D-4.0'
9-D-6.0'
Trunk
S-E-1