Roller Service - Toro Reelmaster 2000-D Service Manual

Roller Service

10
1. Full roller
2. Roller shaft
3. Grease seal
4. Bearing cup
Disassembly
1. Clean inside of roller around both adjustment nuts
and roller shaft ends. Both areas should be free of dirt
and debris.
2. Remove adjustment nut from one end of the roller
shaft. On the sectional roller, remove adjustment nuts
from each end of the roller.
3. Keep roller level and slide the shaft with the remain-
ing adjustment nut out of the roller. On the sectional roll-
er, slide both sectional rollers off the shaft.
4. Secure roller in a vise.
5. Remove outer seals.
Cutting Units
11
4
12
Figure 13
5. Bearing cone (outer)
6. Outer seal
7. Adjustment nut
8. Grease fitting
Page 7 – 14
1
2
3
4
9
2
4
5
6
4
5
6. Remove both bearing cones. On the sectional roller,
remove all four bearing cones.
NOTE: An electric arc welder can be used to shrink the
bearing cup to simplify its removal. Only a small arc in
one location on the cup is required.
7. Remove both bearing cups from the roller. On the full
roller, remove both inner seals. On the sectional roller,
remove all four bearing cups.
8. Discard seals and bearings that were removed from
roller.
5
6
7
8
See assembly process for
tightening procedure
7
8
6
7
8
9. Wiehle roller
10. Sectional roller shaft
11. Bearing cone (inner)
12. Sectional roller
Reelmaster 2000–D