Rsx112A & Rsx115A Rear Panel Layout - Samson RSX M10a Owner's Manual

RSX112a & RSX115a Rear Panel Layout
1. XLR and ¼" Input Connector (Input 1) - This combo
XLR and ¼" connector accepts either a balanced
or unbalanced microphone or line level signal.
The ¼" phone input accepts TS or TRS type
connectors.
2. VOL Control (Input 1) - This Volume knob adjusts
the level of the Input 1 channel.
3. Mic/Line Switch (Input 1) - The MIC position
changes the gain of the Input 1 jacks to MIC
level. The LINE position reduces the gain of both
jacks by 30dB to line level.
4. XLR and ¼" Input Connector (Input 2) - This combo
XLR and ¼" connector accepts either a balanced
or unbalanced line level signal. The ¼" phone
input accepts TS or TRS type connectors.
5. VOL Control (Input 2) - This control adjusts the
level of the Input 2 channel.
6. STATUS Indicator - This bi-color LED lights
GREEN when signal is present at the inputs,
regardless of the input volume control settings.
The indicator lights RED when the amp is near
the clipping point and the limiter is engaged.
If the LIMITER indicator lights frequently, turn
down the INPUT volume controls on the speaker
or turn down the signal at the source, until the
indicator does not light anymore, or lights only
occasionally with high signal peaks.
7. POWER Indicator - The POWER LED lights
indicating that the main POWER switch is on.
8. DSP PRESET - The RSX DSP has three EQ contour
curves: FLAT, BOOST, and VOCAL. The FLAT
setting produces the standard frequency response
and works best for most applications. The BOOST
setting enhances low frequencies to add punch
and high frequencies to add vocal clarity. The
VOCAL setting provides a high frequency lift
for vocal clarity. This is useful when plugging a
microphone directly into the speaker.
9. FRONT LED Switch- When set to the ON position,
the front power LED will illuminate when the
Power LED switch is set to the ON position. When
the switch is in the OFF position, the Front Power
LED will not illuminate.
10