Page 2
By doing so you will ensure that your disposed product undergoes the necessary treatment, recovery and recycling and thus prevent potential negative effects on the environment and human health. Copyright 2014, Samson Technologies Corp. v1.1 Samson Technologies Corp. 45 Gilpin Avenue...
Important Safety Information AVIS RISQUE DE CHOC ÉLECTRONIQUE - NE PAS OUVRIR CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. This lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of non-insulated “dangerous voltage”...
Page 4
Samson products in the future. Also, be sure to check out our website (www.samsontech.com) for complete information about our full product line.
Page 5
Features Here is a look at some the features of the Expedition powered loudspeakers: • 500 watt, two-way active loudspeakers for live sound applications • Ultra-wide, flat frequency response • Custom-designed, heavy-duty, 12”/15” long throw low frequency drivers provide enhanced bass response •...
Quick Start The following steps will help you set up your Expedition XP112a/XP115a loudspeakers. Turn the VOLUME control on the rear panel fully counterclockwise. Set the Contour switch in the out (OFF) position. Turn the Power switch OFF. Connect either a line-level signal from your mixer (or other source) or a microphone to the Input jack on the Expedition XP112a/XP115a rear panel.
Rear Panel Layout XLR & ¼” Combo Input - Use this XLR / 1⁄4” input for balanced micro- phone or line level device. SENSITIVITY Switch (Mic/Line) - The MIC position changes the gain of the input jacks from MIC to LINE level.
Connecting a Microphone Follow these steps to connect a dynamic microphone to your Expedition loudspeaker: • Set the Expedition XP112a/XP115a Power switch to the off position. • Turn the VOLUME control fully counterclockwise to the off position. • Connect the power cable to an AC socket.
Connecting a Stereo Signal Source The following steps describes connecting Stereo Line Level Signal to two Expedition loudspeakers: • Set the Expedition XP112a/XP115a Power switch to the off position. • Turn the LEVEL control fully counterclockwise to the off position. •...
Page 10
Floor Monitor The Expedition XP112a/XP115a is an ideal solu- tion for stage monitoring thanks to its wedge monitor positions. When placed on its side, with the high frequency horn facing to the right of...