Rear Panel Layout - Samson RS112A Owner's Manual

Rear Panel Layout

1.
XLR & 1/4" Combo Input - Use
these XLR - 1⁄4" input for
balanced microphone or line level
devices.
2.
SENSITIVITY Switch (Mic/Line) -
Matches the channel sensitivity to
the input audio source signals.
3.
COMPRESSOR - These knobs adjust
the level of compression applied
to the channel. As the knob is
turned clockwise, the compression
ratio is raised and the output
gain is adjusted accordingly. The
dynamic range of the channel is
narrowed, where softer signals will
be magni ed and loud signals will
be subdued to sit better in the
mix. Too much compression can
create a pumping effect, eliminate
all dynamic range, and lead to
feedback.
4.
Volume Control - This knob adjusts
the level of the Channel 1 and 2
input signals.
5.
Pairing Indicator - Displays the
Bluetooth status of the RS
®
loudspeaker.
6.
Pairing Button - Press this button
to enable discoverable mode to pair
with a Bluetooth audio device.
7.
Volume Control - This knob adjusts
the level of the Bluetooth and Aux
In.
8.
1/8" AUX IN - Connect a line level
device using a 3.5mm audio cable.
9.
XPD WIRELESS Input - Connect a
Samson XPD digital wireless USB
receiver to this input.
10.
MIX OUT - Male XLR connector used to link multiple RS Loudspeaker cabinets.
11.
SIGNAL / LIMIT Indicator - This indicator lights green when signal is present. It will light red
when the amp is near the clipping point and the limiter is engaged.
12.
POWER Indicator - This LED lights GREEN when amp is active.
13.
POWER Switch - Switches on the RS Loudspeaker's main power.
14.
AC Power Inlet - Connect the supplied standard IEC AC power cable here.
15.
Fuse Holder - The fuse holder comes from the factory with the appropriately rated fuse for
your model. If you need to change this fuse for any reason, replace it with one that has the
same exact rating.
10
4
3
2
1
1
C US
11
12
5
6
7
8
9
10
13
14
15