Table of Contents
Advertisement
Driver Installation
You may need to install the proper drivers in your operating system
to use the USB device. Refer to your operating system's manual or
documentation for more information.
Refer to chapter 4 for more information about installing the USB 2.0
drivers.
Wake-On-USB Keyboard
The Wake-On-USB Keyboard function allows you to use a USB
keyboard to wake up a system from the S3 (STR - Suspend To
RAM) state. To use this function:
• Jumper Setting:
JP1 and/or JP5 must be set to "2-3 On: 5V_standby". Refer to
"USB Power Select" in this chapter for more information.
• BIOS Setting:
"USB KB Wake-Up From S3" in the Power Management Setup
submenu of the BIOS must be set to Enabled. Refer to chapter
3 for more information.
Important:
If you are using the Wake-On-USB Keyboard function for 2 USB
ports, the 5V_standby power source of your power supply
must support ≥ 1.5A. For 3 or more USB ports, the 5V_standby
power source of your power supply must support ≥ 2A.
Hardware Installation
2
27
Advertisement
Table of Contents
