Fuji Xerox DocuPrint CP116 w User Manual page 77

NOTE:
• Up to 5 envelopes can be loaded in the multipurpose feeder.
• If you do not load envelopes in the multipurpose feeder right after they have been removed from the packaging, they may
bulge. To avoid jams, flatten the envelops before loading them in the multipurpose feeder. When flattening the envelopes,
firmly press down on the entire surface of the envelopes as shown below.
Feed direction
• If envelopes are still not fed correctly, curl the edge of the envelopes as shown in the following illustration. The amount of the
curl should be 5 mm (0.20 inches) or less, 2 or 3 mm (0.08 or 0.12 inches) is recommended. The area of the curl should be
8 – 10 mm (0.32 – 0.39 inches) from the top edge of the envelopes. Do not curl the envelopes too much or make a crease.
Feed direction
2 or 3 mm
(0.08 or 0.12 inches)
8 – 10 mm
(0.32 – 0.39 inches)
• To confirm the correct orientation of envelopes, see the instruction on the Envelope/Paper Setup Wizard on the print driver.
Printing Basics 77