Programming Other Devices; Operating The Homelink Wireless Control System; Erasing Homelink; In Case A Problem Occurs - Subaru Tribeca 2012 Quick Reference Manual

opener by pressing the programmed
HomeLink button.
®
& Programming other devices
To program other devices such as door
locks, home lighting and security systems,
contact HomeLink at www.homelink.com
or call 1-800-355-3515.
& Operating the HomeLink
Wireless Control System
Once programmed, the HomeLink
less Control System can be used to
remote-control the devices to which its
buttons are programmed. To activate a
device, simply press the appropriate but-
ton. The indicator light illuminates, indicat-
ing that the signal is being transmitted.
& Erasing HomeLink
®
memory
NOTE
. Performing this procedure erases
the memory of all the preprogrammed
buttons simultaneously. The memory
of individual buttons cannot be erased.
. It is recommended that upon the
sale of the vehicle, the memory of all
programmed HomeLink
®
erased for security purposes.
1. Press and hold the two outside buttons
until the indicator light begins to flash
(after 10 seconds).
®
Wire-
®
2. Release both buttons.
& In case a problem occurs
If you cannot activate a device using the
button
corresponding HomeLink
programming, contact HomeLink at
www.homelink.com or call 1-800-355-
3515 for assistance.
buttons be
Rear view camera (if
equipped)
A rear view camera is attached to the rear
gate. When the ignition switch is "ON" and
the select lever is set to "R", the rear view
camera automatically displays the rear
view image behind the vehicle on the
button after
®
navigation monitor or on the inside mirror.
. Since the rear view camera uses
a wide-angle lens, the image on
the monitor is different from the
actual view in terms of distance.
. Since the range of the image on
the monitor is limited, you should
always check the rear view and
6-21
Interior equipment
WARNING
– CONTINUED –