Hard Drive Drive - Tronic PMG Quadpad User Manual

4. Ping the loopback address.
4.1. Click Start, select Programs, select Accessories, and then click
Command Prompt.
4.2. Type the command, ping 127.0.0.1. This will send a message to the
internal network stack on the machine. You should see a response like
this:
Pinging 127.0.0.1 with 32 bytes of data:
Reply from 127.0.0.1: bytes=32 time<1ms TTL=128
Reply from 127.0.0.1: bytes=32 time<1ms TTL=128
Reply from 127.0.0.1: bytes=32 time<1ms TTL=128
Reply from 127.0.0.1: bytes=32 time<1ms TTL=128
Ping statistics for 127.0.0.1:
Approximate round trip times in milli-seconds:
5. Install the latest Service Packs for Operating System or Network Client, if
necessary.
It may be necessary to install Service Packs for either the operating system
or for any additional network clients that may be installed. Contact the
software vendor for these updates which are usually free downloads.
Hard Disk Drive
1. Check that the HDD is recognized in BIOS, and is properly set up in the
startup sequence for the system.
2. Reseat the drive.
3. Use FDISK to verify the drive is partitioned and active.
Packets: Sent = 4, Received = 4, Lost = 0 {0% loss),
Minimum = 0ms, Maximum = 0ms, Average = 0ms
Troubleshooting
55