Using The Battery; Power Supply - Tronic PMG Quadpad User Manual

Power Supply

The PMG Quadpad can be powered using either the built in battery or the AC
Power Adapter plugged into any grounded AC power outlet.

Using the Battery

The primary source of power for the PMG Quadpad is a Lithium-Ion battery
pack. The battery pack will first need to be installed on the underside of the
PMG Quadpad. After following the battery installation instructions below, plug
the AC adapter into any electrical outlet and the PMG Quadpad will begin
recharging immediately. In the future, you should not have to access the
battery pack unless you wish to replace it with a fresh one.
Note:
1. The Battery LED lights green when
charging and will turn off when the
battery is fully charged.
2. When charging the first time, it is
recommended that the battery be
allowed to charge for no less than
eight hours.
3. It will take a longer time to complete the charging process, if the user is
using the PMG Quadpad at the same time.
To install and remove the battery pack:
1. Power down
Quadpad using the Power
Switch.
Installing the Battery:
2. Correctly align the battery
and the notches in the
battery bay. Firmly push the battery toward the PMG Quadpad until it
clicks securely into place.
the PMG
CHAPTER 1 - Getting Started
7