Table of Contents
Advertisement
ASSEMBLY
To hire an authorized service technician to assemble the elliptical exerciser, call 1-800-445-2480.
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
In addition to the included tool(s), assembly requires a Phillips screwdriver
, two adjustable
wrenches
, and a rubber mallet
.
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parenthe-
ses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The
number following the parentheses is the quantity needed for assembly. Note: If a part is not in the hardware
kit, check to see if it has been preassembled.
M8 Split
Wave Washer
M6 Split Washer
(95)–2
M8 x 25mm
M10 x 25mm
(111)–12
Washer (83)–11
Washer (98)–6
Washer (36)–2
#10 x 12.7mm
M4 x 16mm
M8 x 19mm Patch
M8 Locknut
Screw (59)–12
Screw (104)–10
Screw (82)–15
(102)–4
M8 x 38mm
M8 x 56mm Patch
Bolt (96)–4
Screw (94)–2
M8 x 80mm Patch
M10 x 20mm Patch
Screw (84)–2
Screw (66)–2
5
Advertisement
Table of Contents
